Project Engineers (Chemical/Process or Mechanical) with experience in chemical/petrochemical process production or some form of thermal treatment (ex-situ thermal desorption, thermal oxidizers, afterburners, etc.).  Experience with hot chlorinated organic compounds and evaluating/selecting materials of construction for process production and/or treatment vessels.

Skills/Qualifications:

• Bachelors Degree in Chemical Engineering minimum, MS preferred
• Minimum 5-10 years chemical engineering experience, (in a process equipment environment preferred)
• Experience with chemical process equipment including thermal oxidizers, caustic scrubbers, solvent recovery via compression &/or condensation etc.
• Experience with soil and/or groundwater remediation design preferred but not required
• EIT and/or PE preferred

Duties:

• Assist with development of design basis and conceptual Process Flow Diagram
• Perform design calculations (mass and energy balance, air emissions, etc.) for client/agency submittals
• Develop Piping and Instrumentation Diagrams (P&IDs)
• Assist with evaluation and selection of process equipment and cost estimates
• Develop specifications along with remedial design plans and details
• Work cross functionally to facilitate best practices and process initiatives
• Use project management skills to handle multiple projects

Instrument & Controls Technician

Skills/Qualifications:

• 3-5 years experience
• Electrical/Electronic Engineering/Technology degree
• Hands-on work experience in a laboratory or factory setting with operation, testing, calibration and troubleshooting of instrumentation and controls
• Experience with layout, wiring, and/or repair of control panels (UL 508A/B shop experience preferred)
• Experience with programming and configuration using software such as Visual Basic, C, C++, Pearl, etc.
• Experience with field bus protocols such as HART, MODBUS, etc. for instrument configuration, calibration, communication
• PLC programming/configuration (Allen Bradley, Modicon, GE/Fanuc, iDEC, Horner, etc.) & HMI configuration (Wonderware, iFix) experience preferred
• Shop-based position; Some travel to project sites is required for installation, start-up & troubleshooting

Electrical Foreman

Skills/Qualifications:

• 10-15 years experience; Licensed Journeyman or Master electrician 
• Demonstrated experience with single and 3 phase electrical equipment from 120V fractional HP motors to large (5000A) 480V distribution equipment
• Experience with UL508 A/B panels and Class I/Div II wiring preferred

Duties:

• Wire single phase & 3 phase electrical panel boards, switchboards, load centers, transformers, motors, other electrical devices
• Direct electrical subcontractors; inspect electrical subcontractor’s work for conformance with design and code compliance
• Selection of appropriate components for arc flash and short circuit protection
• Establish electrical installation standards for field project construction and shop-built equipment
• Shop-based position; Some travel to project sites is required for construction, start-up & troubleshooting

Field Services Technicians

Skills/Qualifications:

• Knowledge of and experience in Thermal Treatment Systems, Electrical Distribution Systems, Chemical Process Equipment, Boilers, Steam Injection, Industrial Process Equipment, PLC, Ladder Logic, Groundwater Pump & Treat Systems, Heat Exchangers, Air Strippers, Oil/Water Separators, Vapor Extraction Systems, Gas Treatment; Oxidizers, GAC Systems (water and vapor), Acid Gas Scrubbing, Vapor and Water Sampling; 40 OSHA HAZWOPER training.

Duties:

• Help construct, install, and operate remediation systems. 
• Travel extensively to project sites
• Be physically able to work on environmental remediation field sites
• Must pass initial background check and periodic drug screening tests